Sign In / Register

3008DC-DC CNC reducing module is programmable step-down module, digital display has the advantages of small size, high power, high efficiency, reasonable design, materials complete, stable work. Joined the accurate measurement of high-speed micro controller calculation, which can precisely adjust the size of the output voltage and current

Built in 10 sets of memory locations, store and transfer parameters, easy to use. Equipped with four eight segment LED digital tubes, can display the voltage, current, power, capacity and other parameters. At the same time, this machine has the automatic output power, automatic wheel functional display parameters, can be used according to the need to open or close down

Parameters
Input voltage: 6V~32V
Output voltage: 0~30V
Output current: 0~8A
Voltage control / display resolution: 0.01V
The current regulation / display resolution: 0.001A
Power display resolution: 0.001W
Capacity display resolution: 0.001AH
The highest conversion efficiency: 92%
Output ripple: ≤ 50mV
Operating temperature: ~+85 ;mso-bidi-font-family:;color:#333333">-40 degree
Operating frequency: 150KHz
Short circuit protection: constant current
Input reverse connection protection: No, if necessary please install diode
Connection: connecting terminal
Product size (mm): 66 (long) *50 (W) *21 (high)
Weight: 43g

Characteristic
1 All digital display, easy to use
2 Constant voltage, constant current state
3 Output OUT, constant voltage CV, constant current CC indicator
4 NC precise regulation of output voltage and current values
5 Automatic / manual switch to display the voltage, current, power, capacity and other parameters
6 Set after power on whether to automatically output
7 Set the output after the wheel was voltage and current, power, capacity and other parameters
8 ten sets of memory locations, free storage, V
9 Voltage and current push to save the current setting value

Note
1, the correct connection of input and output, no reverse, reverse connection will damage the module.
2, this module is reducing module, input than output above 1.5V.
Following the natural heat can output 6A, output 6A above must be to strengthen the heat